Hardness Tester, K 3175-0000 MANUAL OPERATED
Pellet Hardness Tester, K3175- 0011 MOTOR-DRIVEN OPERATED
With the KAHL hardness tester the
pellet hardness can be determined
immediately after the pellets have left
the cooler without laboratory
equipment.
So a simple quality control can be
achieved during the production process
and the determined values can be used
without delay for optimisation of the
pelleting plant.
This tester can be used for pellets
of different cross-sections up to a
maximum diameter of 22 mm.
The KAHL pellet hardness testers
are available in two designs:
â– tester with manually operated
pressing screw
â– tester with motor-driven pressing
screw
The same basic device is used for
both designs so that the drive is
interchangeable.
The pressing screw of the manually
operated device is turned by hand
periodically at different speeds. The
measured values may slightly vary,
depending on the operator in charge.
The motor-driven tester, however,
works independently of the operator
and the results are completely neutral,
so that the values of different plants
can be used for comparison.